Auto Page MA-200 Manual de instrucciones descargar pdf (Pagina 96)

Chapter 4 Assembly

4.16 Supporting Arm (for DS-L2)

You can mount the camera control unit DS-L2 on the MA200 main body by attaching the supporting arm.

1 Loosen clamp screws (2) using the supplied

hexagonal screwdriver and remove the cover from

the attaching part of the supporting pillar for

dia-Illuminator 100W/supporting arm on

top-surface of the microscope.

2 Align the pins (2) on the lower-surface of the

supporting arm with the holes on the attaching

part. Using the supplied hexagonal wrench (5

mm), secure the supporting arm by tightening the

four hexagonal socket head bolts (M6 x 20 mm).

The standard descriptions on the DS-L2 attaching

part is shown as follows.

• VESA 75 mm standard compliance,

UL1678-compatible

• Attachment screw holes: M4 depth 7 mm

• Tightening torque: 80 to 120N cm

• Leave a clearance of about 100 mm around the

DS-L2 to prevent heat from collecting near the

equipment.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 106 107

Sin comentarios

Auto Page MA-200 Manual de instrucciones Pagina 96